BluNature Pop-Up - Installation

Step by step

The video's chapters, with what to do in each. Click a timestamp to jump there.

1. 1

   See the sprinklers in action

   0:00

   With the BluNature Pop-Up set, you can water a lawn of up to 70 m², for example 7 x 10 metres. Each of the 6 sprinklers has a range of up to 5 metres.

2. 2

   Unpack the set

   0:03

   The set contains everything you need to water your lawn: piping, connectors, and 6 pop-up sprinklers. First, sketch your garden and decide where the sprinklers should go. Let their ranges overlap a bit, so every spot gets water.

3. 3

   Connect a sprinkler

   0:08

   Dig a trench for the pipe along the lawn and connect the sprinklers to the pipe using the connectors.

4. 4

   Bury the sprinklers

   0:10

   Bury the sprinklers so the top sits just below ground level. That way, they stay out of sight, and when they pop up, they can spray freely. Then fill the trench back in with soil.

5. 5

   Connect to the tap

   0:15

   Connect the pipe directly to your outdoor tap using the included connector. A Gardena coupling doesn't fit the hose in this set.

   The set works best at a water pressure of 2 bar, with a minimum of 1 and a maximum of 3 bar. Check the pressure of your tap.

6. 6

   Turn on the tap

   0:20

   As soon as there's water pressure on the pipe, the sprinklers pop up and start watering. You can set the angle for each sprinkler, for example from 90 to 360 degrees. When you turn off the tap, they sink back below ground level.

   With an irrigation computer on the tap, it happens automatically, even while you're on holiday.